en 
pl| Description | Comments | |
❶ |
LEDs | Red LED (L1) - ? - power supply (ON when the device is powered on). Green LED (L2) - ? - RS-485 data transmission (blinking when data is being transmitted). Blue LED (L3) - ? - radio data transmission (blinking when data is being transmitted). |
❷ |
Signal and electrical connection | V - power supply 11,5…27 VDC GND - ground A, B - RS-485 interface |
❸ |
Radio | Radio 868MHz |
| Ethernet version only | ||
❹ |
Power connector | DC-JACK 5,5/2,1mm - V+ (inside), GND (outside) |
❺ |
Communication Terminal | RJ-45 connector for Ethernet LAN connection |
WiOne Master Design
The diagrams and a table with a description of the terminals of the Wi-MA1 and Wi-MA2 receivers are presented below.
WiOne Wi-MA1 Design
WiOne Wi-MA2 Design
| Opis | Uwagi | |
❶ |
LEDs | Red LED (L1) - ? - power supply (ON when the device is powered on). Green LED(L2) - ? - RS-485 data transmission (Blinking when data is being transmitted). |
❷ |
Battery | CR2032 3V battery holder. |
❸ |
Signal and Electrical Connection | V - power supply 11,5…27 VDC. GND - ground. A, B - RS-485 interface (MASTER – to measuring devices). A*, B* - RS-485 interface (SLAVE – to master device PC/PLC/HMI). |
❹ |
Radio | Radio 868 MHz. |
❺ |
Service Interface | Configuration and reading of data using the CODAP-UART-M8 or CODAP-UART-U. |
❻ |
Memory Card Slot | microSD memory card slot. Memory size up to 4 GB. |
| Version with LCD only | ||
❼ |
LCD | Configurable display with backlight. |
| Ethernet version only | ||
❽ |
Power Connector | DC-JACK 5,5/2,1mm - V+ (inside), GND (outside) |
❾ |
Communication Terminal | RJ-45 connector for Ethernet LAN connection |
Be careful when connecting the device. Incorrect connection may damage the device and/or damage other devices that are connected to the device or system.
All connections must be made when the power is off!
All connections must be made when the power is off!